MULTIduct™ Cable Protection
MULTIduct™ is a multiple duct cable protection system, used in the construction of underground ducting systems for under road, tunnels, bridge crossing and buried linear cable routes.
MULTIduct™ Cable Protection units are quickly assembled by connecting metre long sections with a unique push-fit system. The MULTIduct™ system offers a wide range of accessories to deal with tight turns, elevations, natural track curvature and other obstacles.
An innovative, lightweight, structural, cable protection system that offers a modern alternative to traditional cable ducting systems. MULTIduct™ has been designed to offer seamless integration with Cubis’ range of chamber access products such as STAKKAbox™ ULTIMA Connect, enabling enhanced cable management and access. MULTIduct™ can be integrated into the STAKKAbox™ access chamber on-site, or alternatively spigots can be pre-assembled and delivered as a single unit.
Quick Assembly with Secure One Click Connection System
MULTIduct™ offers a unique ‘push fit system’ that is fast and easy to install. During cable pulling, the unique push-fit connection eliminates any disengagement of the units once installed.
Multiple Ducts Combined into One Part
MULTIduct™ combines multiple cable ducts that would traditionally be separated. This results in the need for a reduced excavation resulting in narrower, shallower trenches, no graded backfill between ducts and reduced time, during installation.
Seamless Integration
MULTIduct™ can be integrated into the STAKKAbox™ access chamber on site, or alternatively MULTIduct™ Spigots can be pre-assembled and delivered as a single unit. If the exact duct entry positions are unknown at the time of order, a flexible sliding backfill barrier can be fitted. This barrier allows for up to 150mm vertical alteration enabling the MULTIduct™ entry position to be customised on site.
Available Sizes
MULTIduct™ is available in a range of size options designed to offer seamless integration with Cubis’ range of chamber access and cable protection systems.
- 4 Way
- 4 Way XL
- 6 Way
- 9 Way
Options & Accessories
The MULTIduct™ range can be supplied with the following accessories:
Duct Adaptor & Degree Angles
MULTIduct™ allows for 2° of flexibility within its connection, this results in the creation of a natural bend that can follow the curvature of a track, road or tunnel installation.
When greater bends are required Cubis has designed mitres to assist in any curvature needed. Single way duct adaptors can also be used to offer a seamless integration between traditional ducting and the MULTIduct™ unit.
Sockets & Spigots
Sockets & Spigots are used to join male to male (spigot to spigot) and female to female (spigot to spigot) lengths of MULTIduct™.
Socket & Spigot End Caps
Socket and spigot end caps are used to terminate both male and female duct entry points and can be pre-fitted for simpler construction.
Duct Plugs
Square and corner plugs are used to seal duct compartments to protect against sand, backfill ingress and rodents.